NordicTrack GX 4.1 User Manual page 8

5. Apply some of the included grease to an M6 x
70mm Bolt Set (50).
Orient the Handlebar (5) and the Upright (4) as
shown.
While a second person holds the Handlebar (5)
near the Upright (4), insert the Extension Wire
(59) upward through the Handlebar.
Tip: Avoid pinching the Extension Wire (59).
Attach the Handlebar (5) to the Upright (4) with
the M6 x 70mm Bolt Set (50) and two M8
Washers (43).
Then, attach an M6 x 60mm Bolt Set (51)
through the lower bracket on the Handlebar (5).
6. While another person holds the Console (13)
near the Handlebar (5), insert the long receiver
wire (A) on the Console through the Handlebar
as shown.
Then, connect the other wires on the Console
(13) to the Extension Wire (59) and to the Pulse
Wire (61).
Tip: Avoid pinching the wires. Attach the
Console (13) to the Handlebar (5) with four M4
x 16mm Screws (90).
5
50
43
Grease
51
Avoid pinching the
Extension Wire (59)
6
59
8
59
5
43
50
51
4
Avoid pinching
the wires
13
61
5
A
90