Table of Contents
Advertisement
DHCP Server Configuration
IPX-1000 has a built-in DHCP server that can automatically assign dynamic IP addresses to client PCs
connected to its LAN ports, simplifying the task of IP address management. You can set up two IP
address ranges for the DHCP server to use – the second range will be used only after the first range is
all used up. Being able to set up two IP address ranges makes the system more flexible in terms of IP
address usage.
Please select the DHCP server configuration icon:
DHCP server
Lease Time (min)
Domain Name
Router IP
Assignment IP range
1
Assignnment IP range
2
Parameter Description
Enabele / Disable
Please make sure all the following parameters are set properly before
enabling the DHCP server.
1440 (default value)
The lease time is measured in minutes.
Please insert the domain name of the IPX-1000.
Please insert the router's IP address of the IPX-1000.
If you want to use IPX-1000's internal router, please insert the IPX-1000's LAN
IP address here, or use another router on the LAN then insert its IP address
here instead.
Please insert the first IP address range. The values must be within 1 ~ 254,
and the end value must be greater than the start value.
Note that the first three numbers (unchangeable) should be the same as the
first three numbers of IPX-1000's LAN IP address. If not, then you must
correct IPX-1000's LAN IP address setting first.
Please insert the second IP address range. The DHCP server will start to use
the second range only after the first range is all used up. If you don't need to
use the second range, please instert zero for both the start value and the end
value.
26
Advertisement
Table of Contents
