Changing The Satellite Switching Mode - KVH Industries Cars 2 Innotab User Manual

Changing the Satellite Switching Mode

During normal operation, the antenna automatically switches satellites
as you change channels using the receiver's remote control. However,
if you want to manually select a satellite instead, the interface box
allows you to switch from automatic to manual switching (you can
also switch back to automatic switching using this same menu
function).
NOTE: This function is normally used by technicians for troubleshooting
purposes only.
Follow the steps below to change the satellite switching mode.
1. Press
"DIAGNOSTICS."
2. Press
"DIAGNOSTICS= YES."
3. Press
MENUS until the display shows
DIAGNOSTICS= NO
NEXT MENU
CHANGE until the display shows
DIAGNOSTICS= YES?
CHANGE
ACCEPT to enter the Diagnostics menu.
ENTERING DIAGNOSTICS
TracVision M3/M2 User's Guide
Chapter 5 - Troubleshooting
CHANGE
ACCEPT
49