Table of Contents
Advertisement
7. Loosen the two wing screws securing the LNB to the
choke feed.
Figure 14 LNB Skew Angle Adjustment
Choke Feed
Skew Arrow
Wing Screw
(1 of 2)
LNB
8. Adjust the LNB, clockwise or counter-clockwise, until
the skew arrow on the LNB points to the correct skew
angle on the choke feed.
IMPORTANT!
Make sure the LNB is fully inserted into the choke feed. The
shaft of the LNB must be seated properly against the feed
tube to ensure optimum performance.
9. Tighten the wing screws.
10. Reinstall the radome.
11. Write down the skew angle somewhere so that you can
easily refer to it in the future.
NOTE: If you wish to learn more about how skew works, see
Satellite Signals" on page
6.
TracVision M3/M2 User's Guide
Chapter 4 - Setup
"Linear
33
Advertisement
Table of Contents
