Wall Mount Installation; Power Over Ethernet (Poe) Injector - TRENDnet TV-IP662PI User Manual

TRENDnet User's Guide

Wall mount installation

Please do not mount the camera until after you complete the installation steps from the
CD-ROM. Temporarily place the camera next to your computer.
To attach the metal plates carry out the following:

Remove the two rubber pads under the base of the Camera.

Slide the metal plate onto the base of the camera, making sure that the two
holes on the base of the camera align with the two screw holes on the base of
the camera.

Secure the metal plate to the base of the Camera with the two screws
provided.

The camera can now be mounted to the ceiling or a wall. See the diagram
below for more information.
© Copyright 2014 TRENDnet. All Rights Reserved.

Power over Ethernet (PoE) Injector

A Power over Ethernet (PoE) Injector (sold separately) is designed to supply power to
PoE Access Points, TV-IP662PIs or other PoE Powered Devices (PDs) through the
Ethernet cable. We recommend the TRENDnet TPE-113GI Gigabit Power over Ethernet
(PoE) injector. This product is sold separately. More details are available on the
TRENDnet web site.
To setup a TRENDnet PoE injector (TPE-113GI) with the TV-IP662PI, connect one end of
an ordinary RJ45 cable to the PoE port at the back of the injector, and the other end of
the Ethernet cable to the TV-IP662PI.
Wait for the camera to generate power from the PoE injector, the LED at the front of the
camera will blink green when power is delivered. If you are not getting power from the
injector, please check your equipment or read the PoE injector user manual.
TV-IP662PI
4