Fujitsu LifeBook S710 User Manual page 99

Problem
Shutdown and Startup Problems
The Suspend/Resume 
button does not work.
The system powers up, and
displays power on informa-
tion, but fails to load the
operating system.
Your system display won't
turn on when the system is
turned on or has resumed.
An error message is dis-
played on the screen during
the notebook (boot)
sequence.
Your notebook appears to
change setup parameters
when you start it.
Video Problems
The built-in display is blank
when you turn on your
LIFEBOOK notebook.
Possible Cause Possible Solutions
Suspend/Resume 
In Windows XP, enable the button by going to the Control Panel ->
button is disabled. Power Options Properties and clicking on the Advanced tab. In
the Power buttons area, select the option that best suits your
needs. In Windows Vista, select "Choose what the power button
does".
There may be a soft- Close all applications and try the button again.
ware conflict
You have a secured Make sure you have the right password. Enter the setup utility and
system requiring a verify the Security settings and modify them as accordingly. See
password to load your "BIOS Setup Utility" on page 49.
operating system.
Internal hard drive was 
Use the BIOS setup utility or Primary Master submenu, located
not detected. within the Main menu, to try to auto detect the internal hard drive.
You have installed the Check the Status Indicator Panel for presence of the Security
LIFEBOOK/Security icon. If it is visible, enter your password See "Status Indicator
Application panel. Panel" on page 22.
Power On Self Test See the POST messages to determine the meaning and severity
(POST) has detected a of the problem. Not all messages are errors; some are simply sta-
problem. tus indicators. See "Power On Self Test Messages" on page 96.
Contact your support representative for repairs. This is not a 
The BIOS CMOS hold-
up battery has failed. user serviceable part but has a normal life of 3 to 5 years.
BIOS changes were not Make sure you select Save Changes And Exit when exiting the
saved when you exited BIOS setup utility.
the setup utility.
Move the display and the brightness control until you have 
The display angle and
adequate visibility. Pressing either the [F6] or [F7] keys while 
brightness settings are
holding down the [Fn] key also allows you to change the 
not adequate for your
lighting conditions. brightness level of the display.
93