Power On Self Test Messages - Fujitsu LifeBook S710 User Manual

Power On Self Test Messages

The following is a list of error-and-status messages that the Phoenix BIOS and/or your operating system
can generate and an explanation of each message. Error messages are marked with an *. If an error
message is displayed that is not in this list, write it down and check the operating system documentation
on screen and in the manual. If you can find no reference to the message, contact a support representative.
nnnn Cache SRAM Passed
Where nnnn is the amount of system cache in kilobytes success-fully tested by the Power On Self Test
(POST). (This can only appear if you have an SRAM PC Card installed.)
*Diskette drive A error or Diskette drive B error
Drive A: or B: is present but fails the POST diskette tests. Check to see that the drive is defined with the
proper diskette type in the Setup Utility ("BIOS Setup Utility" on page 49) and that the drive is installed
correctly. If the drive is properly defined and installed, do not use it. Contact your support representative.
*Extended RAM Failed at offset: nnnn
Extended memory not working or not configured properly. If you installed a memory upgrade module,
verify that it is properly installed. If it is properly installed, you may want to check your Windows setup
to be sure it is not using unavailable memory until you can contact your support representative.
nnnn Extended RAM Passed
Where nnnn is the amount of memory in kilobytes successfully tested.
*Failing Bits: nnnn The hex number nnnn
This is a map of the bits at the memory address (in System, Extended, or Shadow memory) which failed
the memory test. Each 1 (one) in the map indicates a failed bit. This is a serious fault that may cause you
to lose data if you continue. Contact your support representative.
*Fixed Disk x Failure or Fixed Disk Controller Failure (where x = 1-4)
The fixed disk is not working or not configured properly. This may mean that the hard drive type identified
in your setup utility does not agree with the type detected by the Power On Self Test. Run the setup utility
to check for the hard drive type settings and correct them if necessary. If the settings are OK and the
message appears when you restart the system, there may be a serious fault which might cause you to lose
data if you continue. Contact your support representative.
96