Help Information - Fujitsu IP-9610 Hardware User's Manual

5.1
5.1
If a problem is found in device operation, take recommended action described in the table below,
according to the applicable conditions. If the action does not solve the problem, contact a service
representative.
Possibility of electric shock
Contact your system administrator before checking the voltage of a power
outlet. Otherwise, electric shock may occur.
Table 5.1 Problem descriptions and recommended actions
No. Class Status
1.
Power cannot
be turned on.
2.
The ALM LED
3.
is blinking.
The ALM LED
4.
is on.
The LEDs
excluding LAN
5.
and Console are
on.
6.
The INDWN
lamp lights in
orange.
7.
The INDWN
8.
lamp blinks in
orange.

Help Information

Description
Is the power cord connected?
Is the outlet voltage normal?
Check the log information from the
browser.
The temperature inside the device
has risen to the critical level or the
fan speed has fallen.
The device is faulty.
Is the ambient temperature of the
device higher than that in the
specifications?
Is there any shielding material in
the installation space?
Is the power to the video/audio
output device (such as a camera)
selected for input turned on?
Is this device correctly connected to
the video/audio output device?
The synchronization slipping
occurs for encoder or the reference
clock input fault occurs for decoder.
Make sure that the power cord is properly
connected to the outlet.
Measure the voltage with a tester to
confirm that the voltage is normal.
If another device is connected to the same
outlet, check the operation of the device.
If the ambient temperature of the device is
too high, make proper arrangements to
lower the ambient temperature. If there is
any shielding material in the installation
space, remove it.
If the fan speed is low, the fan needs to be
replaced. Contact a Fujitsu Service
Center.
Troubleshoot from the control terminal.
(For details, see the software manuals.)
Adjust the temperature so that the ambient
temperature of the device meets the
specification's condition.
Remove the shielding material.
Verify the power supply and operation of
the video/audio output device selected for
input.
Check the cable connection between this
device and video/audio output device.
Make sure that the video input signal for
encoder or the reference clock input signal
for decoder is set correctly.
47
Chapter 5 Troubleshooting
Recommended action
IP-9610