Flight Plan Data Fields; Manually Switching Between Internal And External Flight Plan Sources; Failure Of The External Gps Navigation Source - Garmin G3X Touch Pilot's Manual

Flight Planning

FLIGHT PLAN DATA FIELDS

Changing the information shown in the flight plan data fields:
1) With a flight plan displayed, touch FLP Source > Internal if an external
navigator is configured (Active Flight Plan only).
2) Touch one of the data fields to change.
3) Touch the desired data field.
MANUALLY SWITCHING BETWEEN INTERNAL AND
EXTERNAL FLIGHT PLAN SOURCES
NOTE: The selection of the internal GPS navigation source to persist through
power cycles or reset to the external GPS navigation source is dependant
on the configuration. Refer to the G3X Touch Installation Manual for more
information.
Touch FLP Source > Internal on the Active Flight Plan Page or the Direct-to Page,
to temporarily allow flight planning through the G3X Touch using the internal GPS
flight plan when an external GPS Navigator is configured. Press the FLP Source >
External to return to the external GPS navigator's flight plan.
When manually selecting the internal GPS flight plan, 'INT' is displayed in light blue
in the lower left quadrant of the HSI.
Switching between internal and external flight plan sources:
From the Active Flight Plan Page or the Direct-to Page, touch FLP Source
> Internal or FLP Source > External to switch between the internal and
external flight plan sources when an external GPS Navigator is configured.

FAILURE OF THE EXTERNAL GPS NAVIGATION SOURCE

If the external GPS navigation source fails, the system reverts to the internal GPS
navigation source and 'REV' is shown in yellow in the lower left quadrant of the HSI.
108
Garmin G3X Touch Pilot's Guide 190-01754-00 Rev. A