Oki C9800hdtn Configuration Manual page 64

4
4-12 Performing Setup from the Control Panel
TCP/IP Setup with Ethernet
Network Setup
Protocol Setup
TCP/IP Setup
Ethernet Setup
Enable TCP/IP for Ethernet
Yes/No [Yes]
Select Yes if you have a TCP/IP network connected to the printer over
Ethernet cabling.
If you are using TCP/IP for printing from Windows computers, enabling
N :
OTE
TCP/IP here also enables you to use Fiery utilities from Windows computers using
TCP/IP protocols.
Enable Auto IP Configuration
Yes/No [Yes]
Select Yes to allow the Fiery to obtain its Ethernet IP address by searching the network.
Depending on your network and the protocol you select in the following option
(DHCP or BOOTP), the IP address can change. Select No to assign the Fiery a static
IP address. If you select No, you proceed to the IP Address option, where you manu-
ally set the IP address.
Select protocol
DHCP/BOOTP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select
the protocol over which the Fiery should search for its IP address. Both DHCP and
BOOTP allow the Fiery to obtain the Ethernet IP address and Subnet
Mask automatically.
Depending on your network, the Fiery might be assigned a different address after you
restart the Fiery. With the DHCP setting, the Fiery can be assigned a different address
even if it is not restarted. Make sure the network is already configured properly for the
protocol you select.
Auto Gateway Address
Yes/No [Yes]
Use this option to assign the gateway address automatically for printing with TCP/IP.