Oki C9800hdtn Configuration Manual page 128

5
5-28 Setting up the Fiery from a Windows Computer
Outgoing Mail Server.
Timeout (seconds).
Polling Interval.
Mailbox Account Name.
Fiery E-mail Address.
Password.
Verify Password (remote Setup only). —Reenter your password.
Administrator E-mail Address. —Enter the address specified in Fiery setup.
—Specify the IP address or server name that communicates the appropriate mail server
and contact information to the Fiery.
You must define both an Incoming and Outgoing mail server. If an Outgoing
N :
OTE
mail server is not defined, the E-mail Service assumes that the incoming and outgoing
server names are the same.
—Specify the maximum amount of time that will elapse as the Fiery attempts to
connect to the mail server.
—Specify how often the Fiery checks the mail server for relevant e-mail.
—Enter the mailbox name specified on the mail server. This name tells the Fiery client
mail service which account contains e-mail messages for the Fiery.
The account name entered in this field must first be specified on the mail server
N :
OTE
by the administrator.
—Enter the name of the e-mail account. For example, pat@test.com .
—Enter a password for accessing the mailbox account on the mail server.
The administrator authorizes a unique e-mail address to remotely administer e-mail
services. If an error occurs while you are sending a job via e-mail, E-mail Service sends
an error message to the Administrator E-mail Address specified. The administrator can
authorize additional administrator e-mail addresses from this e-mail address.