Oki C9800hdtn Configuration Manual page 60

4
4-8 Performing Setup from the Control Panel
For this Network or
Connection Type
AppleTalk over Ethernet
TCP/IP over Ethernet
IPX/SPX over Ethernet
Parallel
T N
O ACCESS
1. Confirm that the network cable is connected to the Fiery.
2. Choose Network Setup from the main Setup menu as described on
3. Choose Port Setup from the Network Setup menu.
4. To use Ethernet, choose Ethernet Setup from the Port Setup menu, and enter the
5. To print to the parallel port, choose Parallel Port Setup from the Port Setup menu, and
6. When you have finished entering port settings, choose Exit Port Setup, and then
7. Enter the appropriate settings for the protocol or protocols you will use.
The available network types, and the Setup areas that pertain to them, are summarized
in the following table.
Use this
Port Setup
Ethernet Setup AppleTalk Setup
Ethernet Setup TCP/IP Setup: Ethernet Setup
Ethernet Setup IPX/SPX Setup
Parallel Port Setup
S
ETWORK ETUP OPTIONS
During Network Setup, the Fiery queries the network for zones, servers, and
server-based queues. If you perform Network Setup without a connected and
functioning network, default settings are used that may not meet your needs.
appropriate settings.
enter the appropriate settings.
choose Protocol Setup.
Use this Protocol Setup
—
Use this Service Setup
AppleTalk printing (PAP) is
enabled automatically.
LPD Setup
Web Services Setup
Windows Setup
Port 9100 Setup
IPP Setup
PServer Setup (NDS, Bindery,
or both)
—
page 4-3.