Control Connections (Ss-R1 Only) - Tascam SS-R1 Owner's Manual

1 − Introduction

Control connections (SS-R1 only)

The pinouts of the CONTROL I/O
on the rear panel (see "Rear panel" on page 10) are:
Pin Function
1 GND
2 Play/Flash 1
3 Stop/Flash 2
4 Record/Flash 3
5 ≤ (Next)/Flash 4
6 µ (Previous)/Flash 5
7 Flash Load
8 Fader Start
9 Flash Tally
10 Ready Tally
11 Record Tally
12 Stop Tally
13 Play Tally
2
14 Remote Select*
15 Ready/Flash 6
16 Call/Flash 7
17 Auto Cue/Flash 8
18 Auto Ready/Flash 9
19 Pitch/Flash 10
3
20 Flash Page*
21 EOM Tally
22 CF Tally
23 —
24 —
1
25 +5V*
In: External command reception active flow
(operates at 30 ms or longer of ground)
Out: transport status by open drain
Indication signal (maximum voltage 50 V, maximum current 50
mA)
*1 Maximum supplied current is 50 mA.
*2 Pin 14 (Remote Select)
When this pin is high, the input pins for which the above table
lists two commands separated by a "/" (pins 2–6 and 15–19)
will perform the first-listed function, and can be used as
conventional parallel controllers.
When this pin is low, the above-listed input pins will function
as flash start keys.
*3 Pin 20 (Flash Page)
When pin 14 (Remote Select) is low, the assigned tracks will
be as follows according to the high/low state of pin 20.
#14 #20
Low High
Low Low
Tall signals are open collector, with a maximum current
of 50 mA. Input signals are active when low (ground)
for ≥ 30 ms.
A fader start/stop control should be wired according to the
8
TASCAM SS-R1/SS-R05
( ) terminal
PARALLEL
IN/OUT
—
In
In
In
In
In
In
In
Out
Out
Out
Out
Out
In
In
In
In
In
In
In
Out
Out
—
—
—
Flash-start status
1–10
11–20
following schematic:
Pin 1
STOP
START
GND
PARALLEL
Pin 8
FADER START