Manual Installation - THOMSON TG784 Setup And User Manual

1.2.2

Manual Installation

Requirements
JavaScript must be enabled (this is the default setting) on your browser. For more information, consult the
help of your web browser.
Procedure
Proceed as follows:
1 Connect the Thomson Gateway to your broadband
2 Power on the Thomson
3 Connect your computer to the Thomson
4 Configure the Thomson
This is described in the sections below.
Connect the Thomson Gateway to your broadband service
As described in "User-specific requirements" on page
following scenarios:
DSL Gateway
Home Router
When setting up Thomson Gateway as DSL Gateway
Proceed as follows:
1 Take the DSL cable with the grey connectors. This cable is included in your box.
2 Plug one end of the cable in the grey DSL port on the back of your Thomson Gateway.
3 If you are:
Using a splitter, plug the other end of the cable into the Modem/ADSL out put of your splitter.
Not using a splitter, plug the other end of the cable directly in the wall outlet.
For more information about splitters, see
When setting up Thomson Gateway as Home Router
Proceed as follows:
1 Take an Ethernet cable.
2 Plug one end of the cable in the
E-DOC-CTC-20090619-0010 v1.0
Gateway.
Gateway.
Gateway.
4, you can use your Thomson Gateway in either of the
"Filters and splitters" on page
red WAN port on the back of your Thomson Gateway.
service.
5.
WAN
1 Installation
11