THOMSON TG784 Setup And User Manual page 20

1 Installation
3 Plug the other end into the Ethernet port of your Internet gateway/modem.
The WAN port can only be used to connect your Thomson Gateway to an Internet gateway/modem.
You can not use it to connect your computer to the Thomson Gateway.
Power on the Thomson Gateway
Proceed as follows:
1 Connect the power cord to the Thomson Gateway's power port.
2 Plug the other end into an electrical outlet.
3 Push the power button to turn on the Thomson Gateway.
4 Wait two minutes to allow the Thomson Gateway to complete the start up phase.
Connect your computer to the Thomson Gateway
Setting up a wireless connections
For more information on how to setup a wireless connection to your Thomson Gateway, see
Access" on page
Setting up a wired connection
For more information on how to setup a wired connection (i.e. an Ethernet connection) to your Thomson
Gateway, see "1.4 Connecting a Computer Using the Ethernet Cable" on page
Configure the Thomson Gateway
Proceed as follows:
1 Open your web browser.
2 The Thomson Gateway informs you that you have not yet configured your Thomson Gateway.
If this window does not appear browse to
Gateway (by default: 192.168.1.254) and click Thomson Gateway on the menu on the left-hand side.
3 Click Setup my Thomson Gateway.
4 The Easy Setup wizard appears. This wizard will guide you through the configuration of your Thomson
Gateway. Click Next and follow the instructions.
12
25.
http://dsldevice.lan or to the IP address of your Thomson
"3 Wireless
14.
E-DOC-CTC-20090619-0010 v1.0