Configuring The Thomson Gateway Voip Settings - THOMSON TG784 Setup And User Manual

4 Telephony
4.1.2

Configuring the Thomson Gateway VoIP Settings

Introduction
If you configured your Thomson Gateway using the
configured by the Setup wizard.
If you choose to configure your Thomson Gateway manually or you still need to configure the VoIP settings,
you can follow the procedure below.
How can I check if the VoIP settings have already been configured?
If the Phone LED is:
Solid or blinking green then the telephony service has already been configured. No configuration is
needed.
Off then telephony service is not yet configured. Follow the instructions below.
Requirements
Your Internet connection must be up and running before you can configure Internet telephony.
Configuring the VoIP settings
Proceed as follows:
1 Enter the proxy and registrar
2 Enter your VoIP account
Enter the proxy and registrar settings
Proceed as follows:
1 Browse to the
2 On the Toolbox menu, click Telephony.
3 In the Navigation
4 Complete the following fields with the settings provided by your VoIP provider:
Proxy:
Type the URL (for example: sip.provider.com) or IP address of the proxy.
Registrar:
Type the URL (for example: sip.provider.com) or IP address of the registrar.
Registrar Port and Proxy Port.
In most cases the default port (5060) will be used. Only change these values if your provider is using
other port numbers.
5 Click Apply.
36
settings.
settings.
Thomson Gateway GUI.
bar, click Expert configure.
Guided Installation, the VoIP settings may already be
E-DOC-CTC-20090619-0010 v1.0