Ethernet Connection; Power Supply - Samsung SND-5080 User Manual

installation & connection
Connecting to the monitor
Connect the video out port of the camera to the video input port of the monitor.

M
In the initial installation of the camera, you can connect the camera to the monitor for checking
the connection status.
You must set <Video output> to <On> before the display screen can be activated. (page 68)

Connect the monitor test cable to the output port of the monitor.

You can set the video output type to either NTSC or PAL. (page 68).

Ethernet Connection

Connect the Ethernet cable to the local network or to the Internet.

Power Supply

Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.

J
Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.

If using PoE, the heater will not operate at all.
Use an adaptor if the installation site requires heater operations. Adaptor is sold separately.
For the power specifications, refer to the "Appendix". (page 98)

If PoE and DC 12V are both applied, this camera will get supplied with power from PoE.

Please make sure the monitor and camera are turned off when connecting them.

M
The instructions above are also applied to SND-5080/SND-5080F/SNV-5080.
40_ installation & connection