Samsung SND-5080 User Manual page 15

Item
System, Power,
POWER
SD Indicators
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
J
Reset Button
Power Port Used to plug the power cable.
GND Used for earth-grounding.
Network Port Used to connect a PoE or LAN cable.
ALARM IN
ALARM OUT
I/O Port
ALARM COM Common port where the alarm output signal is connected.
GND
Video Out Port Analog video output port. (for installation)
ON : While the power is on
OFF : If the power is off
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Used to connect the alarm input signal.
Used to connect the alarm output signal.
Used for earth-grounding.
Description
English _15