Locating The Sf51; Resetting The Sf51 - Intermec SF51 User Manual

Cordless scanner

Hide thumbs Also See for SF51:

Table of Contents

Enlarged version

Chapter 3 — Troubleshooting and Maintaining the SF51

Locating the SF51

If your SF51 is within Bluetooth communication range of your

host PC, you can send the Bluetooth Device Page command

from EasySet to locate the SF51.

Note: If the SF51 is turned off, your host PC

cannot connect to it and send the Bluetooth Device

Page command.

To page the SF51

Start EasySet version 5.2 or later. Make sure that SF51 is

selected as your product.

Select Communication > Connect.

Select the appropriate COM port, and click OK.

Select the Send to product check box below the commands

window.

In the EasySet Commands window, select Configuration

modes and utilities > Bluetooth device page.

The SF51 beeps continuously for 1 minute or until you find

the SF51 and press the Scan button.

If the SF51 appears to be locked up, you can reset it. When you

reset the SF51, the scanner control firmware is restarted.

To reset the SF51

• Place the SF51 in the 1-bay or 4-bay charger.

If you have a Bluetooth connection, the SF51 disconnects from

the host device.

SF51 Cordless Scanner User's Guide

Table of Contents