Intermec SF51 User Manual page 38

Chapter 3 — Troubleshooting and Maintaining the SF51
Problems and Possible Solution (continued)
Problem
You are trying to establish a
Bluetooth connection from a
host device to your SF51, but
the host device cannot find
your SF51.
You established a Bluetooth
connection with an Intermec
computer, and the settings
on your SF51 were restored
to their default values.
26
Possible Solution
The SF51 may not be in a
discoverable state. For help, see
"Bluetooth Discoverable" on
page 38.
The SF51 may be connected and
paired to another Bluetooth device.
Scan the following bar code to
reset the SF51 to its default settings
and disconnect Bluetooth
communications. Try establishing a
connection again.
Administrator Reset Factory Defaults
\60\08\55\22
Note: Using the Administrator Reset
Factory Defaults command resets all
settings. As a result, you will lose
Bluetooth communications.
When you connect to an Intermec
computer, all SF51 settings that are
common to the Intermec computer's
internal scanner settings are changed
to the default settings of the internal
scanner. Scan configuration bar
codes, or use Intermec Settings on
your Intermec computer to change
your SF51 settings.
SF51 Cordless Scanner User's Guide