Table of Contents
Advertisement
Voice Mail Service
Base Unit
Press [VM].
1
• The base unit is connected to the telephone line and dials the access number
(p. 43) in speakerphone mode.
• If the base unit beeps 3 times, a voice mail access number is not stored. To
store the number, see page 43.
Follow the pre-recorded instructions.
2
When finished, press [SP-PHONE].
3
• If the handset and the base unit still indicate that you have new messages even
after you have listened to them, turn the voice mail indicators off by pressing and
holding [OFF] until the handset beeps. "Voice Mail" will disappear on the
handset, the Ringer/Message Alert indicator will go out, and the VM indicator on
the base unit will go out.
• If your voice mail service uses a voice mail tone and the recorded message is
over 3 minutes long, the handset and base unit may not indicate that you have
new messages.
• If your voice mail service uses a voice mail tone, the tone will be heard from any
parallel connected phone. If you use another phone to retrieve messages, you
have to dial your access number manually.
46
Advertisement
Table of Contents
