MDT3F & MDT4F User Manual
For The Electrician
Electrical connections:
Check the nameplate for voltage and current
requirements. An electrical cord is not supplied.
Connect the MDT3F or MDT4F to a separate
electrical circuit. Wiring to the machine must
conform to all codes. A licensed electrician may be
required in some situations.
Remove the back panel to make the electrical
connection. The electrical connection is made on
the terminal strip in the junction box inside the
FOLLOW ALL APPLICABLE LOCAL, STATE
machine. Replace the back panel when the
AND NATIONAL CODES
electrical connections are complete.
This Unit MUST BE GROUNDED
Electrical
Power
Remove Back Panel To
Expose Junction Box
November 2008
Page 4