Toshiba TOSVERT VF-S9 Instruction Manual page 172

• Operation mode parameters
Title Communication Function
No.
0300 PWM carrier
frequency
0301 Auto-restart
control selection
0302 Regenerative
power ride-
through control
0303 Retry selection
(number of times)
0304 Dynamic braking
selection
0305 Overvoltage limit
operation
0306 Output voltage
adjustment (Base
frequency voltage)
0307 Supply voltage
correction
0308 Braking resistor
operation rate
0312 Random mode
0360 PI control
0362 Proportional gain
0363 Integral gain
Unit Minimum Adjustment range
setting unit
kHz 0.1 2.0-16.5
- - 0: Disabled
1: At auto-restart after momentary stop
2: When turning ST-CC on or off
3: At auto-restart or when turning
ST-CC on or off
4: Motion of DC braking at start-up
(at auto-restart after momentary
stop)
5: Motion of DC braking at start-up
(when turning ST-CC on or off)
6: Motion of DC braking at start-up
(at auto-restart or when turning
ST-CC on or off)
- - 0: Disabled
1: Enabled
Times 1 0-10
- - 0: Dynamic braking disabled
1: Dynamic braking enabled, over-
load protection disabled
2: Dynamic braking enabled, over-
load protection enabled
- - 0: Enabled
1: Prohibited
V 1 0 to 250V, 0 to 500V
- - 0: Supply voltage uncorrected, output
voltage limited
1: Supply voltage corrected, output
voltage limited
2: Supply voltage corrected (off dur-
ing deceleration), output voltage
limited
3: Supply voltage uncorrected, output
voltage unlimited
4: Supply voltage corrected, output
voltage unlimited
5: Supply voltage corrected (off dur-
ing deceleration), output voltage
unlimited
%ED 1 1-100
- - 0: Disabled
1: Enabled
- - 0: Disabled
1: Enabled
- - 0-01-100.0
- - 0.01-100.0
K-5
E6580757
Default User Reference
setting setting
12.0 6.11
0 6.12.1
0 6.12.2
0 6.12.3
0 6.12.4
0 6.12.5
200V/400V
6.12.6
1 6.12.6
3 6.12.4
0 6.11
0 6.12.7
0.30 6.12.7
0.20 6.12.7
11