IBM IntelliStation M Pro 6220 User Manual page 82

Preinstallation steps
Some of these steps are required only the first time you install a hard disk drive in a
specific bay.
1. Read the safety information beginning on page vii, the guidelines in "Handling
2. Verify that you have all the cables and other equipment specified in the
3. Choose the bay in which you want to install the drive.
4. Check the instructions that come with the drive to determine whether you need
Installing a drive in bay 2 or 4
Complete the following steps to install a drive in bay 2 or 4:
60
IBM IntelliStation M Pro Types 6220 and 6230: User's Guide
static-sensitive devices" on page 29, and the documentation that comes with
your drive.
documentation that comes with the drive.
to set any switches or jumpers on the drive. If you are installing a SCSI device,
make sure that you set the SCSI ID for that device.
1. Follow the instructions in "Preinstallation steps" on page 60.
2. Turn off the computer and all attached devices.
3. Disconnect all external cables and power cords; then, remove the side cover
(see "Removing the side cover" on page 53).
4. Remove the support bracket (see "Removing and installing the support
bracket" on page 54).
5. Use a screwdriver to pry the filler panel and EMC shield away from the
computer.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.