IBM IntelliStation M Pro 6220 User Manual page 64

11. Slide the drive into the drive bay from the front, and then attach the drive to
12. Place the drive cage back into the computer.
13. Connect one end of the IDE signal cable into the back of the drive and the
14. Connect the power cable to the back of the drive. The connectors are keyed
15. If you have other options to install or remove, do so now.
16. Replace the cover and frame-support bracket. See "Replacing the cover" on
17. Reconnect the external cables and power cords; then, turn on the attached
Installing a hard disk drive in bay 3
Complete the following steps to replace or install a hard disk drive in bay 3:
42
IBM IntelliStation M Pro Types 6220 and 6230: User's Guide
the drive cage.
other end of the cable into the IDE connector on the system board. For the
location of the IDE connectors, see "System-board internal connectors" on
page 32
Note: Make sure to route the signal cable so that it does not block the airflow
to the rear of the drives or over the microprocessor.
and can be inserted only one way.
page 48 and "Removing and installing the support bracket" on page 33 for
details.
devices and the computer.
1. Follow the instructions in "Preinstallation steps" on page 38.
2. Turn off the computer and attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the cover and frame-support bracket. See "Removing the cover" on
page 33 and "Removing and installing the support bracket" on page 33 for
details.
5. Disconnect the power and signal cables from both drives in the drive cage.