Situation In Which The Document Is Not Fed Into The Adf Occurs Frequently - Fujitsu fi-6110 Operator's Manual

Chapter 8 Troubleshooting
Situation in which the document is not fed into
the ADF occurs frequently.
Does the paper condition fulfill the requirements described
in "Precautions" in "Paper Quality" (page
Yes
Did you fan the documents before loading them in the ADF
paper chute?
Yes
Are the consumables (*1) installed correctly?
Yes
Are any of the consumables (*1) dirty?
No
Are any of the consumables (*1) worn out?
No
*1: "Consumables" refers to the pad assy and the pick roller.
Use paper that fulfills the requirements.
30)? For details, refer to
No
Fan the documents before loading, or reduce the amount of documents.
No
Install the consumables (*1) correctly.
For details, refer to
No
Clean the consumables (*1).
For details, refer to
Yes
Check the consumable counters and replace them if necessary.
For details, refer to
Yes
If the problem persists, check the items in
Service Provider" (page 121)
an authorized FUJITSU scanner service provider.
"2.2 Documents for Scanning" (page
"Chapter 7 Replacing the Consumables" (page
"Chapter 6 Daily Care" (page 85).
"Chapter 7 Replacing the Consumables" (page
"8.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
Contents
Introduction
Scanner
30).
Overview
How to Load
Documents
Configuring the
Scan Settings
91).
How to Use the
Operator Panel
Various Ways to
Scan
91).
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
115