Motion Recording - Lorex LW2702 series Instruction Manual

Recording

Motion Recording

Use Motion Recording to have the system only record when motion is detected by one of the
cameras. The camera that appears on-screen is the only camera that is recording.
A
Figure 7.3 Recording triggered by motion during the Motion Recording
To enable Motion Recording:
1. Press the Motion button. "AUTO REC" will light up
on the LCD receiver.
2. Perform one of the following:
Enable Quad Mode (
Quad button. When motion is detected, the
system will display the triggered camera on-
screen. When motion recording is complete, the
view will return to Quad Mode.
Enable Auto Sequence Viewing Mode: Press the CHANNEL—A button. When motion is
detected, the system will display the triggered camera on-screen. When motion
recording is over, Auto Sequence Viewing Mode will continue as normal.
Change channels manually: Press the CHANNEL—M button on the wireless receiver or
remote control to select a channel.
ATTENTION: If you manually select a channel while the system is in Motion Recording
Mode, motion recording will
Motion Recording enabled, you manually select channel 3; if motion were to occur in
view of camera 1, the system would NOT RECORD video from channel 1.
3. Press the Motion button again to stop Motion Recording. "AUTO REC" will turn off on the
receiver.
30
recommended
): Press the
ONLY apply to the selected channel
R E C
R E C
B
. For example, with