Heat & Glo SUPREME-I30-SP Owner's Manual page 36

3 3
Figure 5. Place Log #3
Log #3 (SRV2206-702): Position Log #3 as shown in Figure 5. Position the grate tine groove, located on the bottom of the
log, over the base of the left grate tine. Pull the log forward. The back end of Log #3 rests on the log support. Move the
end of Log #3 clockwise until the bottom right corner is fl ush with the pilot bracket.
FRONT END OF LOG FRONT END OF LOG
RESTS ON FLAT RESTS ON FLAT
SPOT SPOT
FLAT SPOTS FLAT SPOTS
FOR LOG #5 FOR LOG #5
Figure 6. Place Log #4
Log #4 (SRV2206-703): Position Log #4 as shown in Figure 6. See Figure 3 for additional references. Place the thick end
of Log #4 on the large fl at spot on Log #1. Rest the front end of Log #4 on the fl at spot of Log #2.
Log #5 (SRV2206-704): Position Log #5 as shown in Figure 7. See Figure 6 for additional details. Mate the grate tine with
the log groove as shown. Position the tips of Log #5 on the fl at spots as shown in Figure 6.
LEFT END OF LEFT END OF
POSITION THE NOSE ON THE POSITION THE NOSE ON THE
LOG RESTS ON LOG RESTS ON
FLAT SPOT FLAT SPOT
Figure 8. Position Log #6
Log #6 SRV(2206-706): Position Log #6 as shown in Figure 8. See Figure 7 for additional references. Rest the left end of
Log #6 on the fl at spot of Log #3. Position the nose of Log #6 on the fork of Log #5.
36 Heat & Glo • Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. K • 6/11
CORNER OF CORNER OF
LOG FLUSH LOG FLUSH
WITH PILOT WITH PILOT
BRACKET BRACKET
PILOT PILOT
BRACKET BRACKET
REST LOG ON REST LOG ON
LARGE FLAT LARGE FLAT
SPOT SPOT
4 4
FORK OF THE LOG FORK OF THE LOG
6 6
FLAT SPOTS FLAT SPOTS
(FOR LOG #6) (FOR LOG #6)
5 5
GRATE TINE GRATE TINE
LOG GROOVE LOG GROOVE
Figure 7. Position Log #5
Figure 9. Log Set Installed
POINTS OF LOG REST ON POINTS OF LOG REST ON
FLAT SPOTS FLAT SPOTS
TOUCHES TOUCHES
2206-935B