Heat & Glo SUPREME-I30-SP Owner's Manual page 33

FLAT SPOT FOR LOG #4 AND LOG #7 FLAT SPOT FOR LOG #4 AND LOG #7
LOG FOOT LOG FOOT
CONTACTS CONTACTS
LOG SUPPORT LOG SUPPORT
Figure 5. Log #2
Log #2 (SRV2205-701): Position Log #2 as shown in Figure 5. Mate the right grate tine with the log groove. Rest the back
of the log on the log support. Rotate the back of the log clockwise until the foot contacts the vertical wall of the log support.
LOG GROOVE LOG GROOVE
CONTACTS CONTACTS
GRATE TINE GRATE TINE
Figure 7. Log #3
Log #3 (SRV2205-705): Position the log groove with the 2nd grate tine from the right. Rotate the right end of the log
clockwise until the end of the log contacts the grate bar.
FLAT SPOT FOR FLAT SPOT FOR
LOG #6 LOG #6
LOG GROOVE LOG GROOVE
CONTACTS CONTACTS
GRATE TINE GRATE TINE
Figure 9. Place Log #4
Log #4 (SRV2205-704):
Figure 9. Set the other end of the log on the fl at spot located on Log #2. See Figure 5.
Log #5 (SRV2205-710): Mate the notch on Log #5 with the second grate tine from the left as shown in Figure 10. Set the
other end of the log on the fl at spot of Log #1. See Figure 3.
Heat & Glo • Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. K • 6/11
2
MATE TINE WITH MATE TINE WITH
LOG GROOVE LOG GROOVE
FLAT SPOT FLAT SPOT
FOR LOG #7 FOR LOG #7
3
LOG CONTACTS LOG CONTACTS
GRATE BAR GRATE BAR
END OF LOG RESTS END OF LOG RESTS
ON FLAT SPOT ON FLAT SPOT
4
Position Log #4 so that the log groove contacts the second grate tine from the left, as shown in
SURFACE SURFACE
CONTACTS CONTACTS
LOG SUPPORT LOG SUPPORT
Figure 6. Log #2
LOG GROOVE LOG GROOVE
Figure 8. Log #3
LOG RESTS ON LOG RESTS ON
FLAT SPOT FLAT SPOT
LOG NOTCH LOG NOTCH
CONTACTS CONTACTS
GRATE TINE GRATE TINE
Figure 10. Place Log #5
LOG FOOT LOG FOOT
FLAT SPOT FOR FLAT SPOT FOR
GRATE BAR GRATE BAR
5
33