Heat & Glo SUPREME-I30-SP Owner's Manual page 35


G. Install the Log Assembly
Log Set Assembly: LOGS-I30
Models: Supreme-I30, Supreme-I30-SP, Supreme-I30AU
LOG SUPPORTS
LEFT GRATE TINE
Figure 1.
CAUTION: Logs are fragile, handle with care. Log #1 (SRV2206-701): Bend the log tab into the upright position as shown in
Figure 1. Position Log #1 as shown in Figure 2. The left end of the log should rest on the log support. Mate the right end of the log
with the right grate tine. Rotate log clockwise, until the right end of the log engages the right grate tine, and the left end of the log
touches the log tab shown in Figure 1.
2 2
MATE SLOT WITH LOG PIN MATE SLOT WITH LOG PIN
Figure 3. Log #2
Log #2 (SRV2206-705): Position Log #2 as shown in Figure 3. Mate the slot located on the bottom of Log #2 (Figure 4) with the
log pin located on the surface of the burner. Rotate the right end of Log #2 clockwise, until it comes into contact with the grate tine.
Heat & Glo • Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. K • 6/11
#6 #6
SRV2206-706 SRV2206-706
#4 #4 SRV2206-703 SRV2206-703
#1 #1 SRV2206-701 SRV2206-701
LOG TAB
LOG PIN
RIGHT GRATE TINE
FLAT SPOTS FLAT SPOTS
FOR LOG #4 FOR LOG #4
GRATE TINE FITS GRATE TINE FITS
IN LOG GROOVE IN LOG GROOVE
#2 #2
SRV2206-705 SRV2206-705
#5 #5 SRV2206-704 SRV2206-704
SRV2206-702 SRV2206-702
#3 #3
LOG LOG
SUPPORT SUPPORT
Figure 2. Install Log #1
SLOT SLOT
Figure 4. Place Log #2
1 1
LOG RESTS ON LOG RESTS ON
GRATE TINE GRATE TINE
2 2
35