Brother DCP-J4110DW Basic User's Manual page 63

Error Message
Cannot Detect
Cannot Detect Ink
Cannot Print
Replace Ink
Cover is Open
Data Remaining
High Temperature
Hub is Unusable.
Cause
You installed a new ink cartridge too
quickly and the machine did not detect
it.
An ink cartridge is not installed
correctly.
If you are using non Brother Original
ink the machine may not detect the ink
cartridge.
If you are using non Brother Original
ink, the machine may not detect the
ink volume.
One or more of the ink cartridges have
reached the end of their life. The
machine will stop all print operations.
The scanner cover is not completely
closed.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The print head is too warm.
A hub or USB Flash memory drive with
hub has been connected to the USB
direct interface.
Troubleshooting
Action
Take out the new ink cartridge and
re-install it slowly until the cartridge
lever lifts. (See Replacing the ink
cartridges on page 47.)
Replace the cartridge with a Brother
Original ink cartridge. If the error
message remains, contact Brother
customer service or your local Brother
dealer.
Replace the cartridge with a Brother
Original ink cartridge. If the error
message remains, contact Brother
customer service or your local Brother
dealer.
Replace the ink cartridges. (See
Replacing the ink cartridges
on page 47.)
Lift the scanner cover and then close it
again.
Make sure the USB cable (if used) has
been guided correctly through the
cable channel and out the back of the
machine.
Firmly close the ink cartridge cover
until it clicks.
Press . The machine will cancel
the job and clear it from the memory.
Try to print again.
Allow the machine to cool down.
Hubs, including USB Flash memory
drives that have a built-in hub, are not
supported. Unplug the device from the
USB direct interface.
B
55