Table of Contents
Advertisement
What's Included
GPS antenna and
metal plate
hook-and-loop
fasteners (2)
Installing the Main Unit
Use the screws or the hook-and-loop fasteners provided to mount the main unit in the vehicle. Select a location that allows you to
access the SD card slot on the unit.
Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills, or liquids.
Check for cables or other parts underneath the À oor mat before cutting the À oor mat.
Installing the GPS Antenna
Do not paint the antenna. This will impair or disable signal reception.
Remove any object or accumulated snow, etc., from the top of the antenna. It will reduce reception strength.
Do not pull the cord when removing the antenna or adjusting its position. This can cause a short or break the wires.
The permanent adhesive on the back of the metal plate is extremely dif¿ cult to remove after it is installed.
The GPS antenna can be installed either inside or outside the vehicle. It should be mounted horizontally for best GPS reception.
The GPS antenna must have a clear view of the sky. If you install the antenna inside the vehicle, place it close to a window. GPS
signals can pass through glass but not through metal. Refer to the image on the next page for recommended places to install the
antenna. Place the GPS antenna on a metallic surface, such as the roof of your vehicle, for best reception. If a metallic surface is not
available, mount the GPS antenna on the enclosed metal plate. See the next page for further instructions.
Installing Optional Accessories
For information on installing the optional FM traf¿ c receiver, refer to the installation guide included with the traf¿ c receiver.
main unit
M3 x 12 machine
screws (4)
M3 nuts (4)
owner's manual
M3 x 12 thread-
forming screws (4)
installation manual
n
n
CAUTION
n
n
CAUTION
- 2 -
wiring harness
warranty card
caution card
Advertisement
Table of Contents
