Drc Setup; Dual Mono Setup - Samsung HW-D600 User Manual

✎
NOTE

Setting the calibration takes about 3 minutes.

Because the volume level of the tone is fi xed during the Auto Calibration setup, you cannot adjust
the volume using the volume control.

If the ASC microphone is disconnected during the Auto Calibration setup, the setup will be
canceled.

You can also press the ASC button on the remote control to use this function.

If Dolby Pro Logic ||z is set to ON, the selection are in the following sequence :
FL CEN FR

DRC Setup

You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
DRC compresses the audio to make the loudest sounds quieter and the quietest sounds louder.
1. Press the SETUP/MENU button on the remote control.
•
Each time the button is pressed, the mode switches between
INPUT and SETUP OFF.
2. Press the ▲▼ buttons to select OPTION, and then press the
ENTER button.
3. Press the ▲▼ buttons to select DRC, and then press the
ENTER button.
4. Press the ▲▼ buttons to set the DRC you want.
•
AUTO : The Dynamic Range Control will be set automatically
based on the information provided by the Dolby TrueHD
Soundtrack.
•
MIN : Sets DRC effect to minimum.
•
STD : Sets DRC effect to standard.
•
MAX : Sets DRC effect to maximum.

Dual Mono Setup

Dual mono programs have two independent mono channels.
You can use this function when dual mono programs are played.
When you use this function, select audio channels CH1, CH2 or both Channel.
1. Press the SETUP/MENU button on the remote control.
•
Each time the button is pressed, the mode switches between
INPUT and SETUP OFF.
2. Press the ▲▼ buttons to select OPTION, and then press the
ENTER button.
3. Press the ▲▼ buttons to select DUAL MONO, and then press
the ENTER button.
4. Press the ▲▼ buttons to select the DUAL MONO option you
want.
•
CH1 : Channel 1 is heard only.
•
CH2 : Channel 2 is heard only.
•
BOTH : Both channels are heard from front speakers.
SR FHR FHL SL SW.
45