Radio Shack TAD-1017 Owner's Manual page 28

43-776.fm Page 28 Friday, August 13, 1999 3:34 PM
2. When the outgoing message be-
gins (or the TAD sounds a series
of beeps), press
your 2-digit PIN within 2 seconds.
The message stops, and the TAD
announces "You have xx new
message(s)" (where xx is the
numbers of messages) or "You
have no messages," then plays a
series of voice prompts to guide
you through remote operation.
3. Press , then, within 2 seconds,
press the number key for the com-
mand you want.
Press:
1 Repeat current mes-
sage.
2 Play messages and
memos.
3 Skip current message
during playback.
4 Delete current mes-
sage during playback.
5 Record a memo.
6 Set the TAD to answer/
not answer calls.
7 Stop playback of mes-
sages, memos, or the
outgoing announce-
ment; end recording of
memo and outgoing
announcement.
8 Record a new outgoing
message.
0 Play the voice prompts
again.
28
Notes:
then enter
To:
• You can enter the command while
the TAD is announcing the num-
ber of messages or during the
voice prompts.
• If you do not enter a command
within 20 seconds after the voice
prompts end, the TAD hangs up.
• The TAD stores all messages until
you delete them.