Memory Dialing; Storing A Number In Memory - Radio Shack TAD-1017 Owner's Manual

43-776.fm Page 17 Friday, August 13, 1999 3:34 PM

MEMORY DIALING

You can store up to 10 numbers in
memory, then dial a stored number by
pressing a one-digit memory location
number.

Storing a Number in Memory

1. Lift the handset. If you hear a
tone, press
TALK
2. Press . The TALK/BATT LOW
MEM
indicator flashes.
3. Enter the number and any tone or
pause entries (see "Using Tone
Services on a Pulse Line" on
Page 16 and "Entering a Pause"
on Page 18).
Notes:
• An error tone sounds and the
phone exits the programming
mode if you wait more than 20
seconds to press a key.
• Each number you store can be
up to 16 digits long.
• Each tone or pause entry uses
one digit of memory.
to turn it off.
4. Press , then enter a memory
MEM
location number (
sounds to indicate that the num-
ber is stored.
Note: If five quick beeps sound,
you have made an entry error and
the number was not stored. Start
again from Step 2.
5. For each stored number, write the
person's or company's name next
to the appropriate location number
on the supplied sticker. (Use a
pencil in case you want to change
the number later.) Attach the
sticker to the phone.
To erase a stored number, simply
store a new number in its place. Or,
press MEM twice, then press the mem-
ory location number (
0
clear. A tone sounds.
0 – 9 ). A tone
– ) you want to
9
17