Setting The Relative Volume Level Of Each Channel - RCA Professional Series Owner's Manual

After you assign a component to the digital
jack, whenever you select that component,
for example a DVD player, the receiver
automatically changes to the digital input
setting and
DIGITAL
Setting the Relative
Volume Level of Each
Channel
Default setting:
0 dB
For best surround sound playback, you
should set the relative channel levels from
the main listening position. You can set
seperate levels for each surround mode.
1 Press
STANDARD
2 Press
TEST TONE
test tone.
The test tone is output in the following
order (depending on the speaker setting):
FL
SW
Note:
If you do not hear a test tone from one of
your speakers, please refer to "Speaker
Setting" on page 34 to make sure you have
correctly specified your speaker setup.
3 Press
MASTER VOLUME +/–
adjust the volume to an appropri-
ate level.
4 Use
LEVEL +/–
speaker levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in
the main listening position. The channel
level range is ± 10 dB.
shows in the display.
.
to output the
C FR
SL SR
to
to adjust the
Setting Up the Receiver
5 When you are done, press
to turn off the test tone.
TONE
Notes:
• Test tone is only output in Standard
modes.
• Since the subwoofer transmits an ultra-
low frequency its sound may seem
quieter than it actually is.
• The speaker volume can be adjusted
without outputting the test tone by
pressing
CH SELECT
.
LEVEL +/–
STANDARD
CH SELECT
TEST
TONE
TEST
and then using
MASTER
VOLUME
LEVEL
37