Dynamic Range Control Setting; Dual Mono Setting; Coaxial Digital Input Setting; Optical Digital Input Setting - RCA Professional Series Owner's Manual

Setting Up the Receiver
Use or
surround speakers from the main
listening position (within a 30 foot
range).
Note:
When is selected in the speaker setting,
S
the surround distance cannot be set.
Dynamic Range Control
Setting
Default setting:
Dynamic range is the difference between the
loudest and softest sounds in any given
signal. With this setting, you can compress
the dynamic range, so that low level sounds
can be heard more easily (sounding
relatively louder) yet louder sounds will not
be too overbearing.
Press or
range control (
Notes:
• When listening at low volumes, set to
for maximum dynamic range
MAX
compression.
• Dynamic range control is effective only
when a Dolby Digital signal is being
played back.

Dual Mono Setting

Default setting:
The dual mono setting can only be used
when listening to Dolby Digital discs with
dual mono encoding. These discs are not
widely used, but are sometimes used when
it is necessary to have one language on one
channel and a different language on the
other. With this setting you can choose
which channel in the dual mono setting you
want to listen to.
36
to set the distance of the
OFF
to set the dynamic
, , or
OFF MAX MID
ch1
If Dolby Digital mode is switched on, you
will hear the channel you have selected
(either
ch1
speaker. With Dolby Digital mode off, or if
you do not have a center speaker, you will
hear the channel you have selected through
both front speakers. In the
setting, the left front speaker will play
channel 1 and the right front speaker will
play channel 2.
Use or
possible dual mono settings.

Coaxial Digital Input Setting

Default setting:
).
Here you tell the receiver what component
you have connected to the coaxial digital
input jack.
Use or
digital input (DVD, TV, CD, CD-R,
VCR or OFF).
After you assign a component to the digital
jack, whenever you select that component,
for example a DVD player, the receiver
automatically changes to the digital input
setting and

Optical Digital Input Setting

Default setting:
Here you tell the receiver what component
you have connected to the optical input
jack.
Use or
digital input (DVD, TV, CD, CD-R,
VCR, or OFF).
or ) through your center
ch2
L ch 1. R ch 2
to cycle through the
L ch 1.R ch 2
ch2 ch1
DVD
to select the coaxial
shows in the display.
DIGITAL
TV
to select the optical