Brother P-Touch 3600 User Manual page 94

ERROR MESSAGE LIST
ERROR MESSAGE
CUTTER ERROR!
DIVIDE BY ZERO
ERROR!
EEPROM ERROR!
INPUT WHOLE CODE!
84
CAUSE
G This message appears if the cut-
ter did not operate correctly.
G This message appears if the
conversion rate entered when
setting up the Euro conversion
function was 0.
G This message appears if a
checksum error occurred when
the P-touch was turned on or if
the keyword was damaged and
failed to initialize.
G This message appears if the set
number of digits is not entered
in the barcode data.
SOLUTION
G Turn off the P-touch, and
then turn the P-touch on
again.
G If the problem cannot be
corrected, contact your
service representative.
G Type in a conversion rate
other than 0.
G Contact your service rep-
resentative.
G Input the correct number
of digits or change the
number of digits set in the
barcode parameters.