A S SE MB LY ST E P
HARDWARE BAG CONTENTS :
SUPPORT BARS
A S SE MB LY ST E P
YO U ' RE F I N I S HE D!
12
SUPPORT BAR BOOT
BOLT (E)
(8 TOTAL)
STEP C
SUPPORT BAR
POWER SWITCH
CIRCUIT BREAKER
A Open HARDWARE BAG .
B Slide SUPPORT BARS onto side
MOUNTING BRACKETS and
line up with top MOUNTING
BRACKETS.
C Insert 2 BOLTS (E) into the
tops and 2 BOLTS (E) into the
bottoms of each SUPPORT BAR.
The BRACKET should be on the
outside of the SUPPORT BAR
as shown in the drawing to the
left.
MOUNTING BRACKET
D Slide SUPPORT BAR BOOTS
down to cover BOLTS (E).
BRACKET
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a beep
and the console will light up.