Horizon Fitness CardioCORE CT61 User Manual page 8

P R E - A S S E M B LY
WARNING
NOTE:
It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to
prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
AS S E MB LY S T E P 1
HARDWARE BAG FOR STEP 1 CONTENTS :
* NOTE: If the straps have been removed before completing step 1-D and the linkage arms can not be aligned,
refer to the TROUBLESHOOTING section (page 26) in order to restore the treadmill to its proper position.
7
DO NOT CUT STRAPS UNTIL STEP 1-E!*
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Remove plastic wrap from console masts.
BOLT A
1
3
2
A Open HARDWARE BAG FOR STEP 1.
��������
B Lift LEFT CONSOLE MAST into
�������
upright position. Be sure to hold
������
the console mast firmly, as it will
not stay in the upright
position on it's own.
LEFT CONSOLE MAST
C Move LEFT SIDE LINKAGE ARM
into position. Insert BOLT (A) and
tighten.
D Repeat on the right side.
E Now cut the banding straps and
remove remaining packaging
LEFT SIDE LINKAGE ARM
material.*
F Lift the RUNNING DECK until lock
latch on side of treadmill is fully
engaged.
G Remove CONSOLE from box
and place out of the way.
H Lower the treadmill RUNNING
DECK from the folded position by
stepping on LOCK LATCH on lower
right side.
Disassemble box and remove the