IBM System x3620 M3 7376 Installation And User Manual page 86

11. Connect the power cables and the signal cable (see "Internal cable routing and
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 78. Go to the Setup utility and make sure all
the installed DIMMs are present and enabled.
70
System x3620 M3 Type 7376: Installation and User's Guide
Attention: If the fan power cable is not connected correctly, the server
will not start up when you turn on power.
v To connect the fan power cable on the fan board, orient the fan power
connector so that the release tab points faces the rear of the server;
then, connect the cable to the connector on the system board.
v To connect the other end of the fan power cable on the power-supply
paddle card, orient the fan power cable so that the release tab faces the
front of the server; then, connect the cable to the connector on the
power-supply paddle card.
The following illustration shows the correct fan power cable connections.
connectors" on page 31); then, secure the cables with any retention clips.