Fan-Sink - HP ProDesk 600 G4 SFF Maintenance And Service Manual

Fan-sink

NOTE: The fan-sink spare park kit includes replacement thermal material.
Follow these steps to remove the fan-sink:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
a. Front bezel (see
b. Drive cage (see
c. Shroud (see
Remove the fan-sink:
1. Disconnect the fan-sink cable (1) from the system board.
2. Loosen the four slotted Torx-15 captive screws (2) that secure the fan-sink to the computer chassis.
NOTE:
the processor, it may be necessary to move the fan-sink from side to side when removing the it.
3. Remove the fan-sink (3).
Reverse this procedure to install the fan-sink.
Access panel on page
Front bezel on page
Drive cage on page
Fan shroud on page
Due to the adhesive nature of the thermal material located between the fan-sink and
Preparation for disassembly on page
29), and then remove the following components:
31)
34)
38)
28).
Fan-sink 39