Trouble Shooting - Philips 170C6FS/00 Service Manual

36
Common Problems
Having this problem
No Picture
(Power LED not lit)
No Picture
(Power LED is amber or yellow)
Screen says
Screen says
AUTO button not working
properly
Imaging Problems
Display position is incorrect
Image vibrates on the screen

Trouble Shooting

Check these items
·
Make sure the power cord is plugged into
the power outlet and into the back of the
monitor.
·
First, ensure that the power button on the
front of the monitor is in the OFF position,
then press it to the ON position.
·
Make sure the computer is turned on.
·
Make sure the signal cable is properly
connected to your computer.
·
Check to see if the monitor cable has bent
pins.
·
The Energy Saving feature may be
activated
·
Make sure the monitor cable is properly
connected to your computer. (Also refer to
the Quick Set-Up Guide).
·
Check to see if the monitor cable has bent
pins.
·
Make sure the computer is turned on.
·
Make sure the vertical sync of input signal
is within the range of 56 ~ 75 Hz.
·
Change the refresh rate to 56~75Hz within
10 minutes.
·
Re-power on monitor to start over again if
you failed to change the refresh rate within
10 minutes.
·
The Auto Function is designed for use on
standard Macintosh or IBM-compatible
PCs running Microsoft Windows.
·
It may not work properly if using
nonstandard PC or video card.
·
Press the Auto button.
·
Adjust the image position using the
Horizontal Position and/or Vertical Position
in OSD Main Controls.
·
Check that the signal cable is properly
connected to the graphics board or PC.