Philips 170C6FS/00 Service Manual page 48

48
Step 5: Write DDC data
1. Configuration should be as Fig. 19. And press OK.
2. Access Factory Mode
- Turn off monitor.
- [Push AUTO " " & OK "
hold it ] + [Press power "
screen"] => then release all button
3. Click (Write EDID) icon from the tool bar to write DDC data.
Step6:
-1. Disconnect the monitor power cord and connect it again.
-2. Press the OK button to bring up the OSD main manu.
-3. Re-confirm the serial Number is updated as shown in Fig.20.
Step 7: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
in other IC chip. To save DDC data, follow the steps below:
1. Click (Save) icon (or click "file"-> "save as") from the tool bar
And give a file name as shown in Fig. 21.
The file type is EDID45 file (*.ddc) which can be open in WordPad.
By using WordPad, the texts of DDC data & table (128 bytes, hex
code) can be modified. If DDC TEXTS & HEX Table are completely
correct, it can be saved as .ddc flie to re-load it into DDC IC for DDC
Data application.
DDC Instructions
Fig. 19
" buttons at the same time and
" button untill comes out "Windows
Fig.20
Fig. 21
Save
2. Click .
Step 8: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 22.
Edid45.1
Fig. 22