Indication For Usb Memory; Indication For Ipod Mode; Bluetooth Mode - Alpine CDE-126BT Owner's Manual

Indication for USB memory

• Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
USB memory is a malfunction or it is shorted.
- Connect another USB memory.
UNIT ERROR
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
NO DEVICE
• A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
NO SUPPORT
• Text information that is not recognizable by the unit has been input.
- Use a USB memory device with input text information that is
supported by the unit.

Indication for iPod Mode

• The iPod/iPhone is not connected.
- Make sure the iPod/iPhone is correctly connected (refer to
"Connections").
Make sure the cable is not bent excessively.
• There are no songs in the iPod/iPhone.
- Download songs to the iPod/iPhone and connect to this unit.
• Communication error.
- Turn the ignition key off, and then set to ON again.
- Reset the iPod.
- Check the display by reconnecting between the iPod/iPhone
and this unit, using the iPod/iPhone cable.
• Caused by the iPod/iPhone Software Version not being
compatible with this unit.
- Update the iPod/iPhone Software Version to be compatible
with this unit.
• The iPod/iPhone is not verified.
- Reset the iPod.
- Try another iPod/iPhone, if available.
• Power surge error.
Excessive voltage/current is supplied to the iPod/iPhone.
- Try another iPod/iPhone, if available.

BLUETOOTH mode

• The BLUETOOTH device is not connected.
- Connect the BLUETOOTH device.
Indication for all Modes
• Malfunction occurred as a result of the speaker cable shorting on
the car chassis.
- Route the cable correctly, and set POWER IC to POW ON
(page 18).
If the above solution does not work, consult your nearest
dealer.
29
-EN