Hoover SPIRIT Spirit Vacuum Cleaner Owner's Manual page 15

To maintain the cleaning effectiveness of your rug and floor nozzle, the
brushes and litter pickers (on some models) will need replaced occa-
sionally.
Refer to the section that shows the rug and floor nozzle that you
have purchased.
Replacing brush, litter picker and furniture
guard on rug/floor nozzle
When to replace
Replace the brush and litter picker
on the rug and floor nozzle when
they become worn and are not
doing a satisfactory job of loosen-
ing dirt.
How to replace
1. Remove four screws and take
off bottom plate. Note position of
old brush. Then remove it.
2. Locate new brush tabs in the
springs. Make sure the projections
on the side of the brush base are
toward the front of the nozzle.
3. Remove the combination litter
picker and furniture guard. Re-
place with new, positioning the
litter picker and furniture guard in
the grooves along the edge of the
nozzle with litter picker towards
the front of the nozzle. Make cer-
tain litter picker and furniture
guard are seated properly.
Position brush and springs. Re-
place bottom plate. If bristles are
caught beneath the bottom plate,
disengage with any thin tool.