Sharp UP-600 Service Manual page 97

(13) Mount fixing levers (L) and (R) and PF gear on to
the PF shaft assembly, and fasten with E-rings (E4).
(14) Attach the fixing lever spring to fixing levers (L)
and (R).
(15) Insert the paper guide spring into pressure roller
shaft assembly.
Note: Pressure roller shaft assembly refers to
the pressure roller shaft with mounted
pressure rollers.
(16) While pushing the pressure roller springs (L) and
(R) towards the front side, mount the pressure
roller shaft assembly in the PF housing.
Note: After mounting, verify that the pressure
roller springs (L) and (R) are firmly
engaged in the grooves of the pressure
roller shaft assembly.
E-ring
Fixing
lever (L)
Pressure
roller spring (L)
Fixing
lever spring
PF shaft
assembly
Groove
(Apply ORELUBE G 1/3)
Pressure roller
shaft assembly
Groove
(Apply ORELUBE G 1/3)
Fixing lever (R)
PF gear
E-ring
PF housing
Pressure
roller spring (R)
Fixing
lever spring
Paper
guide spring
13
(17) Apply FLOIL G-337 to the PF armature tip. Then
mount the PF solenoid assembly to the PF housing
and fasten it with fixing screws (M3x8).
Apply
FLOIL G-337
PF housing
(18) Install the pull paper guide to the pressure
roller shaft assembly.
Note: When installing, engage one end of the
paper guide spring in the top right cutout
of the pull paper guide and the other end
in the slit of the PF shaft assembly.
Pull paper guide
Pressure roller
shaft assembly
Fixing screws
PF solenoid
assembly
Cutout
Paper guide spring