Sharp UP-600 Service Manual page 100

(30) Mount the motor assembly and motor spacer on to
the right side of the main frame assembly and
fasten with fastening screws (M3x5).
Note: Mount the motor so that the lead wires are
on the bottom side.
Motor assembly
Main frame
assembly
(31) Apply ORELUBE G-1/3 to the three pivots on the
right side of the main frame assembly.
Main frame
assembly
(32) Mount the motor gear on the shaft of the motor assembly.
(33) Install the bevel gear 1 and fasten with E-ring (E2) over
the bevel gear 1 pivot.
Motor spacer
Fastening
screws
Pivot
(Apply ORELUBE G-1/3)
16
Main frame
assembly
(34) Install the idle gear 1 and idle gear 2 and the winder
pulley assembly.
Note: 1. Winder pulley assembly refers to the
winder pulley with the idle gear 2 installed.
2. Mount the winder gear 2 and the winder pulley
assembly while disengaging the securing
hook.
Securing hook
Main frame
assembly
E-ring
Motor gear
Bevel gear 1
Bevel gear 1
pivot
E-ring
Winder pulley
assembly
Idle gear 2
Idle gear 1