Hoover SpinScrub Owner's Manual page 4

The assembled cleaner will look like this
drawing.
1-4
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
1-7
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place.
4
Assemble handle
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
1-5
B
Place nuts in recessed areas on back of
handle. Hold each nut in place while
tightening each bolt securely (from the
front of the handle) with a Phillips screw
driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
1 - 8
Attach tool holder
Remove tool and taped screw from
holder.
Insert projections on holder into slots on
back of cleaner.
1-3
With hose hook (A1) and cord hook (A2) to
back of deep cleaner, push upper handle
down onto lower handle. Push b o l t s i n t o
holes on f ront of handle. If bolts will not
go through hole easily handle is not
pushed completely dow n .
1-6
D
When handle sections are completely
together, squeeze trigger (C) and
depress Clean Surge™ Button (D) on
upper handle.
You will hear a "snap"when the trig-
ger rod is in place.
1 - 9
Slide rack down into place. Insert screw
at (E) and tighten with a Phillips screw-
driver.
A1
A2
C
E