Honeywell TE923W User Manual page 14

E. WIND CUPS SHAFT
Holds wind cups on the anemometer arm
F. BATTERY COMPARTMENT
Holds 2 AA-size batteries
G. WALL MOUNT SCREW OPENINGS
Allows securing the anemometer in place
H. BATTERY COVER
Secures battery compartment on the anemometer base
Assembly
•
Slide the wind cups on to the anemometer rotating shaft. Do not use force.
•
Insert the longer arm of the Allen Wrench (provided) into the wind cup set screw opening.
Feel the head of the set screw inside the wind cups and tighten carefully the set screw
securing the wind cups to the rotating shaft.
•
Test to ensure cups are securely fastened to the shaft and cannot be removed
Battery installation
•
Remove four (4) screws from the battery compartment with a small Phillips screwdriver.
•
Open the battery compartment and install 2 "AA" size alkaline batteries (not included)
matching the polarities shown.
•
Do not close battery compartment yet as you need to make sure that the anemometer
sends the signal to the main unit (0.0 mph will appear on the main unit's wind window if
the signal was sent and received successfully)
Aligning
This procedure must be performed after main unit has been powered and all remote weather
sensors signals were received successfully.
•
Manually point the wind direction vane to the north (use a compass or map if necessary).
•
Press the "SET" button located inside battery compartment (on the shorter side) with a
paper clip. "SET" button selects a new direction for NORTH and, when pressed
repeatedly, alternates between the factory default NORTH and user selected NORTH.
•
Watch for the next anemometer data transmission in the main unit's wind window – the
direction will be updated
•
Replace the battery compartment door and secure the screws.
Note: Repeat aligning procedure every time after changing the batteries.
Mounting
Mount the anemometer onto a vertical surface, using the fittings provided.
Placement tips:
•
The anemometer should be mounted in an open area with a free air flow; away from the
14